Arduino Sketch upload issue – avrdude: stk500_recv(): programmer is not responding

I had this problem with a Crowduino, running the Arduino IDE on OS X. The solution for me was to switch on verbose output during upload (in the Arduino IDE preferences pane).

Then, when uploading, you can see AVRDUDE sending three packets avrdude: Send: 0 [30] [20] (with corresponding RX flashes on the board) right before the avrdude: ser_recv(): programmer is not responding error.

The trick is to hit the reset button on the board immediately before these three packets are sent. Then the program will be uploaded successfully.

Related Posts:

  1. Arduino Sketch upload issue – avrdude: stk500_recv(): programmer is not responding
  2. avrdude: stk500v2_ReceiveMessage(): timeout
  3. How to convert int to string on Arduino?
  4. avrdude: ser_open(): can’t open device “\\.\COM3”: Access is denied
  5. Arduino Nano – “avrdude: ser_open():system can’t open device “\\.\COM1″: the system cannot find the file specified”
  6. Bitwise operation |= in C
  7. arduino suddenly shows “avrdude: ser_open(): can’t open device “\\.\COM3” after last upload
  8. ATMega328P “AVRDude: Could not find USBTiny Device (0x1781/0xc9f)”
  9. try/catch block in Arduino
  10. Windows .NET API / Windows 7 / Bluetooth communication with Intel Curie Arduino / Genuino 101
  11. Control an Arduino with Java
  12. Arduino IDE can’t find ESP8266WiFi.h file
  13. Arduino IDE can’t find ESP8266WiFi.h file
  14. Arduino Leonardo – “avrdude: butterfly_recv(): programmer is not responding”
  15. Arduino sprintf float not formatting
  16. Mapping a numeric range onto another
  17. Arduino IDE is not showing any port macOS
  18. How to convert an ASCII char to its ASCII int value?
  19. how to stop a loop arduino
  20. How to store data in the flash memory of a Arduino Uno (ATmega328p)

Leave a Comment

tech